Neumann KH 80 DSP Active Studio Monitor (SINGLE) (White)

Neumann's digital signal processing architecture brings mathematically optimised waveguide technology to an ultra-compact near-field monitor with exceptional power reserves. The KH 80 DSP Active Studio Monitor uses a DSP engine to filter and align audio output for reference-class performance in project studios, broadcast vans, and mobile recording environments. Its white polycarbonate composite cabinet houses a custom-modelled alloy fabric dome tweeter and long-throw composite sandwich cone bass driver, both engineered to minimise harmonic and intermodulation distortion across the frequency spectrum. The elliptical Mathematically Modelled Dispersion waveguide controls sound direction with computer-simulated precision, delivering a free field frequency response of 53 Hz to 21 kHz (-6 dB) and 0.7 dB linearity deviation between 100 Hz and 10 kHz. Maximum SPL reaches 108.8 dB in half space at 1 metre, driven by bi-amplified Class D power with separate thermo limiters for woofer and tweeter protection. The rear Acoustical Control switch offers four-position low-mid adjustment for quick setup on desks or free-standing positions, while network connectivity enables room correction via the optional MA 1 measurement microphone and Automatic Monitor Alignment software. Analogue input accepts XLR or 6.3 mm jack with 14k Ohms impedance and electronically balanced signal chain, whilst digital conversion runs at 24-bit/48 kHz with 2 ms latency in linear phase mode. Flow-optimised bass reflex ports reduce compression at high output levels, with pipe resonance damping maintaining clarity during sustained low-frequency reproduction. The one-piece front panel eliminates discontinuities that cause edge diffraction, contributing to the monitor's 0.26 dB reproduction accuracy tolerance across the critical 100 Hz to 10 kHz range. A universal switched-mode power supply operates across 100-240 V mains, whilst auto-standby mode reduces consumption when the monitor is inactive. The KH 80 DSP pairs with the KH 750 DSP subwoofer for extended low-frequency response, and every unit is pair-matched to any other KH 80 DSP for consistent stereo imaging. Features  DSP-controlled bi-amplified design with mathematically modelled elliptical waveguide for precise dispersion Free field frequency response 53 Hz to 21 kHz (-6 dB), 0.7 dB linearity 100 Hz-10 kHz Maximum SPL 108.8 dB at 1 metre half space, 104 dB(C) short-term with IEC-weighted noise Custom alloy fabric dome tweeter and composite sandwich cone bass driver with linear motor design Four-position acoustical control switch for desk/free-standing placement plus network-based MA 1 alignment support 24-bit/48 kHz digital conversion with 2 ms latency and 114 dB(A) dynamic range A-D Electronically balanced XLR/6.3 mm jack input with 14k Ohms impedance and symmetrical signal routing Universal 100-240 V switched-mode power supply with auto-standby and flow-optimised bass reflex ports